Make your court portable

PORTABLE KIT

Models: Mundial / Challenger / Wilson Elite

  • The portable kit is made up of two rear modules of 10 cm and four side modules of 8 cm.
  • The rear modules are connected to the 10 cm floor reinforcements. The side modules are attached to the 4 m floor reinforcements and to the pillars.
  • To add weight, steel plates 2 m long and 1 cm thick are added in order to anchor the court correctly and prevent it from shifting.

Contact us for more information

Take your facilities to the next level

Characteristics

NET POST PLATE

2 metal sheets of 1500x1500x10mm, placed under each net pole. These two metal plateswill support the tension of the net.

HANDLING THE PORTABLE KIT

To handle the sheets of the portable kit we will need a forklift given the weight of each ofthe sheets.

CONSTRUCTION CHARACTERISTICS OF THE PORTABLE KIT

  • The rear modules measure exactly 9,908mm, while the side modules measure 7,975 mm. The tubes are 80x40x1.5mm.
  • The rear modules have three angles, since the 10m floor reinforcement tube is higher than the tube used to build the portable kit. The same happens in the modules that go on the sides, since they have two angles to get attached to the 80×80 tube of the side floor reinforcement and two steel strips to get attached to the pillars.KIT 10MKIT 8M.

The steel plates added to generate enough strength to keep the court from moving are distributed as follows:

  • 3 steel plates in each of the rear modules.
  • 2 steel plates in each of the side modules

Therefore, the total number of steel plates amounts to 14, assuming approximately 1,000kg of additional weight.

CONTACT US

Characteristics

NET POST PLATE

2 metal sheets of 1500x1500x10mm, placed under each net pole. These two metal plateswill support the tension of the net.

HANDLING THE PORTABLE KIT

To handle the sheets of the portable kit we will need a forklift given the weight of each ofthe sheets.

CONSTRUCTION CHARACTERISTICS OF THE PORTABLE KIT

  • The rear modules measure exactly 9,908mm, while the side modules measure 7,975 mm. The tubes are 80x40x1.5mm.
  • The rear modules have three angles, since the 10m floor reinforcement tube is higher than the tube used to build the portable kit. The same happens in the modules that go on the sides, since they have two angles to get attached to the 80×80 tube of the side floor reinforcement and two steel strips to get attached to the pillars.KIT 10MKIT 8M.

The steel plates added to generate enough strength to keep the court from moving are distributed as follows:

  • 3 steel plates in each of the rear modules.
  • 2 steel plates in each of the side modules

Therefore, the total number of steel plates amounts to 14, assuming approximately 1,000kg of additional weight.

CONTACT US